INSTALLATION
- Clean vehicle surface (door/hood) where graphic will be placed.
- Clean magnetic number/placard back side.
- Holding the graphic on each end (near the middle), place the TOP INCH of the graphic against vehicle (align with body panels/seams/windows/etc), and let it adhere. Move your grip down to the bottom left/right corners, while still holding the rest of the graphic off the vehicle (but the top is slightly stuck in place). While holding the bottom of the graphic taught between your hands, put the bottom of the graphic against the vehicle. The graphic should be held in place.
- You can also use the strips included in your kit to hold down the leading edge of the graphic. This greatly reduces the risk of the graphic getting lifted off the vehicle during higher speed events. While using the leading edge strip is not required, it is recommended. The leading edge strips are REQUIRED if using the magnetic placard during rain (high speeds can cause the rain to flow under the magnetic and cause lift off).
REMOVAL & STORAGE
- When finished with the graphic, remove the leading edge tape (if installed).
- Lift graphic up from both bottom (or top) corners, keeping the graphic taught in between your hands.
- Slowly pull the graphic off vehicle from bottom to top (or top to bottom), but NEVER side to side as this can crease the graphic.
- Once you have the graphic off the vehicle, clean thoroughly, and place back in the shipping tube/sleeve for your next event.